How to change FPD-Link 3 Operating Mode (CSI-2 mode -> raw mode)
-
I want to change Operating mode (CSI-2 mode -> raw mode)
How can I do this?
I know the input mode of operation is controlled by the FPD3_MODE(Register 0x6D[1:0])
How can I set the value of this MODE?
please let me know the process..I'm using CS-FPD-XAVIER-nCAM Series DevKit and TI DS90UB913A-Q1 Camera.
-
@yongjin
Since our camera module do not support raw output mode, I think it is meaningless to change the fpdlink mode to raw. -
@veye_xumm I have cam(TI DS90UB913A-Q1 serializer) which can be operated raw mode and I want adapt them to Jetson xavier via FPD-LINK3-2RX. Can you explain how to do it?
-
@yongjin Because we do not do raw camera module, so we really do not have this kind of debugging experience. It should be just to adjust some registers.
-
@veye_xumm Can you explain how to adjust registers? I have no experience about that.
-
@yongjin via i2c
-
@veye_xumm
Hi Xumm.Unfortunately, I can't understand your meaning.
Please let me know more detail procedure.one more If adjusting by I2C, it needs another special tool??
Please understand I'm beginner on this technique
-
@yongjin
I don't know what your current state of knowledge is. If you don't understand i2C, you don't understand fpdlink, you don't understand registers. I think you should first learn the basics and be able to understand the information and code we provide now, and then proceed to your next work.
Good luck.
